Additional information
| Brand |
|---|
The D250LS is perfect for installations that include adding a local source to a multiroom system. The D250LS allows the source (e.g., a PC or TV in the bedroom) to automatically override the audio playing in that particular room of a distributed audio system. When the local source is turned on, the amplifier switches the room speakers to its own output. This amplifier also provides autosensing line and amplified inputs as well as a trigger input for versatility in different applications.
The D250LS is rated at 50 watts per channel into 8 ohms and 75watts per channel into 4 ohms. In bridged mode the D250LS is rated at 150 watts of power into a single 8-ohm load. Each amplifier output channel incorporates robust protection circuitry for safety and reliability under extreme circumstances.
The D250LS Amplifier meets EU Standby Power Requirements.
Features –
- Switches speakers between a local source and a distributed audio system
- Four mounting options available with included hardware
- Low-profile design permits use in areas most amplifiers won’t fit
- Channels are bridgeable to create one channel with substantial power output
- Robust circuitry is designed for long-term stability
| Amplifier Channels | 2 |
| Channel Separation | >60dB @ 1 kHz |
| Frequency Response | 20 Hz to 20 kHz +/- 0.4 dB |
| Fuse Rating | T3.15AL/250V |
| Input Impedance | 47 kilohms Line Input |
| Input Sensitivity | 70 mV for 1 watt at 8 ohms 550 mV for 50 watts at 8 ohms |
| Power Consumption (Standby) | <0.5 watts |
| Power Output | Continuous Stereo: 50 watts per channel at 8 ohms (<0.3% THD+N) @ 1kHz 75 watts per channel at 4 ohms 150 watts at 8 ohms, 2 channels bridged |
| Power Requirement(s) | North American: 120 VAC 60 Hz 2.5A European: 230 VAC 50 Hz 2.5A IEC 320 type connector with 3 terminal detachable power cord |
| Signal to Noise Ratio | >112 dB A-weighted |
| Switching Delay | 5 seconds to 5 minutes |
| Total Harmonic Distortion | <0.3% THD+N from 20 Hz to 20 kHz for 50W into 8 ohms <0.05% from 20Hz to 20kHz for 1W into 8 ohms |
| Trigger Input(s) | 12 VDC 10 kilohms |
| Trigger Output(s) | 12 VDC 100 mA max |
| Voltage Gain | 32 dB |
| Zone Outputs | 1 |